A Garage Door Motor Is An Essential Part of Garage Door Openers

Replace Garage Door- The large width and height that garage doors need to have to permit easy entry and egress of vehicles require a lot of effort to operate the mechanism that closes and opens the doors. This is made easy by fitting a garage door motor on the mechanism so that operations require just the touch of a button.  Your local garage door repairs Redcliffe expert can definitely help you with any garage door motor replacement concerns you may have.

garage door motor replacementThese garage door motors do the heavy lifting that operating these doors requires and makes it convenient to use the garage without having to step out of the home or vehicle, especially when it is raining. Motors and openers come in various sizes and you must choose the right size for the door you have installed. A motor with extra power will only cost you more and waste the horsepower installed. One that is too small for the lifting job can cause a lot of strain on the motor of the opener and lead it to become dysfunctional in a short time.

Most garage door opening mechanisms have the same simple way of working. A carriage assembly runs alongside a rail that is positioned between the motor and the garage front and has a motor connected to it. This carriage assembly is connected to the garage door with an arm, and when you activate the motor, the carriage assembly will either pull or push the garage door to operate it.

The weight and size of the door can depend on its actual dimensions and the material of which the doors are made. Wooden doors are heavier than metal ones. Insulation can also add to the weight. Most garage door motors are anywhere between a third of horsepower to one horsepower. Most single car garage doors will be opened by motors of 1/3 H.P. if they are made of lightweight material. Average weight double doors or heavier single doors may require 1/2 H.P. motors, while larger doors, like those for two-car garages, may require anywhere between 3/4 to 1 H.P. Garage door openers will have a screw or belt-driven openers or chain openers that make more noise but are easier to repair.

How Much Does it Cost to Replace Garage Door Opener Motor?

The prices of these door openers can depend on the mechanism as well as the size and weight of the door. Consider a price of between $150 to $200 for a chain-driven opener, but factor in a similar additional Cost to Replace Garage Door Opener Motoramount for its installation. Quieter openers with belt drives
may require you to add $100 to the cost of an opener with installation costs remaining the same. Additional safety features and remote access can add to the price of the openers.

How do you change a garage door opener motor?

Garage door motors may not last as long as the openers can work easily for 10 to 15 years and may need replacement if they burn out or stop functioning in any way. To do this you need to switch off the power supply, disconnect the motor from the garage door mechanism, and then undo all the connections between the motor and the opening mechanism. The motor may then be removed from its mountings, and replaced with a new motor. Make sure that the horsepower of the replacement motor is the same as the one before, or of an increased horsepower if you are replacing the motor because it has been inadequate.

At times, especially if you have a remote control, signals from other devices can interfere with the working of the opener and require it to be reset. Most manufacturers will have detailed instructions in their booklet that tell you how this can be done. The latest models enable resetting with just the operation of a single button.
Look after your garage door motor as well as you look after the mechanism of the door and it should give you good service for at least two decades.

How Much Does It Cost To Replace A Garage Door Cable?

If your garage door is not opening or has become jammed, you may need to replace the garage door cables. Unless you have the proper tools and know-how, this is a job best left to a professional due to the weight of the garage door and the extreme tension of the springs. The cost of repair will vary depending on your location, the length of the cables you need, and the time it takes the pro to do the replacement.  The installation cost of a sectional door cable can range from $30 – $150 depending on size and strength required.  For your security and reliable request a free quote and be sure to mention your brand name.

Also, ask about the warranty that comes with the installation so that you can compare online and make an informed decision.


5 Responses to “How Much Does It Cost To Replace A Garage Door Motor”

  1. Sinita

    our single garage auto tilt door has stopped working. We request a free quote please.
    kind regards

  2. Michael Matheson

    Our garage door opener doesn’t work sometimes on hot days, it’s quite an old model. Looking for a quote to have a new garage door opener supplied and installed. Located in South Lake, Perth

  3. Mark Dahl

    My garage door chain got lose and needed balancing. Here is what my door garage guy’s quote I just wanted to see if this is the average quote—
    285 spring
    Long rollers 250
    Labour 150
    Total 685plus tax

Leave a Reply

You must be logged in to post a comment.

Trackbacks and Pingbacks:

  1. Common Mistakes When Replace Your Garage Door Motor

    […] how much you will spend on the garage door motor replacement cost is crucial so as not to get unexpected financial surprises. Here is what to […]

  2. How Can Reduce Your Garage Door Opener Replacement Costs

    […] Benefits : Okay, now let us move to financial point of view. A typical garage door motor replacement cost can range between $200 – $500 depending on model and complexity of the system. By maintaining […]